Whirlpool 8559 Manual de instruções de utilização - Página 11
Procurar online ou descarregar pdf Manual de instruções de utilização para Máquina de lavar roupa Whirlpool 8559. Whirlpool 8559 13 páginas. 8kg, 1200rpm, washing machine with microban anti-bacterial protection 8003437443664 awoe 8559
Imprimir página
30106320GB.fm Page 11 Tuesday, December 1, 2009 10:47 AM
Red
Indication
indication
on display
lights up
from "F03" to "F35"
(except "F18" and
from "F40" to "F43"
"F02" or "FA"
"Service"
"F18" or "FoD"
Black process 45.0° 130.0 LPI
"Electrical module fault"
Push the "Reset" button for at least 3 seconds.
"F24")
"Electrical module fault"
Make sure that the water tap is open. If yes:
• Switch the washing machine off by turning the programme
selector to the "Off/O" position; then turn the programme
selector to a wash programme again. If there is still a failure:
• Push the "Reset" button for at least 3 seconds.
"F24"
"Water level too high" (after programme cancellation or false
operating). Switch off the washing machine by turning the
programme selector to the "Off/O" position. Turn the
programme selector to a wash programme again, shortly press
the "Reset/Drain" button and press "Start (Pause)" within 15
seconds to start the Drain programme.
"Waterstop fault"
For models with big display, the red "Waterstop" symbol
will also light up in this case.
Turn the programme selector to the "Off/O" position, pull out
the mains plug and turn the water tap off. Tilt the appliance
forward carefully to allow collected water to flow out from the
bottom. Then:
• Plug in the appliance again.
• Turn the water tap on (if water immediately flows into the
appliance without the appliance being started, there is a failure;
turn off the tap and notify the After-Sales Service).
• Select and start the desired programme again.
"Overfoaming"
Too much foam interrupted the wash programme.
• Select and start the "Rinse & Spin" programme.
• Afterwards select and start the desired programme again,
using less detergent. See also paragraph "The machine is at a
standstill...." on first page of Troubleshooting Guide.
If any of the faults described above persist, unplug the
appliance, turn off the water tap and contact our
After-Sales Service (see next chapter).
GB 11
Description
Causes
Solutions