Whirlpool 859991537390 사용자 설명서 - 페이지 10

{카테고리_이름} Whirlpool 859991537390에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 859991537390 19 페이지.

페이지 인쇄

5. Add detergent

Pull out the detergent dispenser and add

detergent (and additives/softener) into the relative

compartments as described in section "DETERGENT

DISPENSER". Observe the dosing recommendations

on the detergent pack.

Correct dosing of detergent / additives is important, because:

• it optimizes the cleaning result

• it avoids irritating residues of surplus detergent in your

laundry

• it saves money by avoiding waste of surplus detergent

• it protects the washing machine by avoiding

calci cation of components

• it respects the environment by avoiding unnecessary

environmental burden.

6. Delaying the start of a programme

• To set a programme to start at a later time, see the

section "OPTIONS/ START DELAY"

7. Start programme

• Press the "Start/Pause"

illuminates, the door locks and the "Door locked"

indicator lights up.

• To avoid over ow, do not open the detergent

dispenser during a running programme anymore.

• The remaining programme duration can vary. Factors

like unbalance in the wash load, or foam formation, can

have an e ect on the programme duration.

8. Change the settings of a running programme, if

needed

You can still change the settings while a programme is

running. The changes will be applied, provided the respective

programme phase has not nished yet.

To change the settings of a running programme:

• Press "Start/Pause"

on pause.

• Change your settings.

• Press "Start/Pause"

programme.

If you have changed the programme, do not add detergent

for the new programme.

To prevent that a running programme is changed by accident

(for instance by children), use the "Key lock"

"FUNCTIONS").

Pause a running programme and open the door, if

needed

• Press "Start/Pause"

• Provided water level or temperature is not too high,

the "Door locked"

open the door, for example to add more laundry, or to

remove laundry which was loaded by mistake.

• Press "Start/Pause"

programme.

9. Cancelling a running programme, if needed

• Press and hold the "ON/OFF"

washing machine stops.

• If the water level and temperature are low enough, the

door unlocks and may be opened.

• The door remains locked if there is water in the drum.

To unlock the door, switch the washing machine on,

select the "Spin & Drain"

spin option o by setting the spin speed to "0".

• The water is emptied and the door unlocks at the end

of the programme.

. The relative indicator lamp

to put the running programme

again to continue the

(see section

to pause a running programme.

indicator light turns o . You can

to proceed with the

button until the

programme and turn the

10. Switch o the washing machine after programme End

• At the end of the cycle, the message "END" is shown on

the display.

• The door can only be opened when the symbol "Door

locked"

light turns o .

• Check that the "Door locked"

open the door and take out the laundry.

• Press "ON/OFF"

To save energy, if the washing machine is not switched

o manually with the button, it turns o automatically

approximately 30 minutes after the end of the programme.

Leave the door ajar to let the interior of the washing

machine to dry.

User manual

indicator is o , then

to switch the washing machine o .