Whirlpool AWE 7515 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Whirlpool AWE 7515에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWE 7515 19 페이지.

페이지 인쇄

IFU-TL HR GB.fm Page 14 Friday, November 7, 2008 2:30 PM

If your washing machine has no time display, check which of the previously described

situations could be the origin of the fault and follow the corresponding instructions.

Black process 45.0° 100.0 LPI

Downloaded From WashingMachine-Manual.com Manuals

Indication on display

Red indication lamp

(if fitted on your

lights up

(in case your washing

machine has no

display: all lamps of the

programme sequence

indicator light up)

from "F02" to "F35"

(except "F09")

"Service"

machine)

"bdd"

Appliance stops during the programme.

"Drum flaps open" (the drum flaps have not been

closed properly).

Push the "Reset" button

and wait until the "Door open"

lid and close drum flaps, then select and start

desired programme again. If fault persists, notify our

After-Sales Service.

"Electrical module fault"

Select and start "Drain" programme or push

"Reset" button

"F09"

"Water level too high" (after programme

cancellation or false operating). Switch off appliance

and then switch it on again, select programme

"Drain" and start within 15 sec.

"FA"

"Waterstop fault"

Switch off appliance, pull out mains plug and turn

water tap off. Tilt appliance forward carefully to

allow collected water to flow out from the bottom.

Then:

• Plug in the appliance again.

• Turn the water tap on (if water immediately flows

into the appliance without the appliance being

started, there is a failure; turn off the tap and notify

After-Sales Service).

• Select and start the desired programme again.

"Fod"

"Overfoaming"

Too much foam interrupted the wash programme.

• Select and start "Rinse & Spin" programme

• Afterwards select and start desired programme

again, using less detergent.

If faults persist, unplug the appliance, turn off the

water tap and contact our After-Sales Service (see

next chapter).

GB 14

Description

Causes

Solutions

for at least 3 seconds

lights up. Open

for at least 3 seconds.