Whirlpool AWO D5306 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool AWO D5306에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWO D5306 14 페이지.

REMOVING THE FILTER

We recommend that you check and clean the filter

regularly, at least two or three times a year.

Especially:

• If the appliance is not draining properly or if it fails to

perform spin cycles.

• If the pump is blocked by a foreign body (e.g. buttons,

coins or safety pins).

IMPORTANT: make sure the water has cooled

before draining the appliance.

1. Stop the appliance and unplug it.

2. Remove the plinth by holding it tight on both sides,

pushing it downward and tilting it to the front.

3. Place a container beneath it.

4. Open the filter but do not remove it completely.

Slowly turn the filter counterclockwise until the water

begins to drain out.

5. Wait until all the water has drained.

6. Now unscrew the filter completely and remove it.

7. Clean the filter and the filter chamber.

8. Check that the pump rotor moves freely.

9. Re-insert the filter and screw it in clockwise as far as it

will go.

10. Pour about 1 litre of water into the detergent drawer

to reactivate the "Eco system". Check that the filter is

inserted properly and securely.

11. Reinstall the plinth.

12. Plug in the appliance once again.

13. Select a programme and start it.

Before emptying the residual water, switch the appliance off and unplug it from the mains socket.

Remove the plinth. Place a container beneath it.

1. Open the filter but do not remove it completely. Slowly turn the filter counterclockwise until the

water begins to drain out.

2. Wait until all the water has drained.

3. Now unscrew the filter completely and remove it.

4. Tilt the appliance forwards carefully to allow the water to flow out.

5. Re-insert the filter and screw it in clockwise as far as it will go.

6. Reinstall the plinth.

Before using the washing machine again:

1. Pour approx. 1 litre of water into the detergent drawer to reactivate the "Eco system".

2. Plug in the appliance once again.