Whirlpool Cabrio WTW6200VW0 사용 및 관리 매뉴얼 - 페이지 8
{카테고리_이름} Whirlpool Cabrio WTW6200VW0에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Cabrio WTW6200VW0 48 페이지. Automatic washer
페이지 인쇄
Laundry tub drain or standpipe
drain
Connecting
the drain hose form to the corrugated
drain hose
S
4.5"
(I 1.4 cm)
_1_
A. Drain hose reliefs
1. Feed end of drain hose into one end of form. Place end of drain
hose form into the drain hose relief.
2. Bend the hose over the top of the form and feed into the other end
of the form. Attach the other end of the form into the other drain
hose refief. The hose must extend 47/2" (11.4 cm) beyond the form.
To keep drain water from going back into the washer:
•
Do not force excess drain hose into standpipe. Hose should
be secure but loose enough to provide a gap for air.
•
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose form on to the corrugated
drain
hose. You may need additional parts. See Floor drain under
"Tools and Parts."
1=
Cesseet _,,se_s_e_ I: (ses
Insert new flat washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
A
B
A. Coupling
B. Washer
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
2. Attach the hose labeled hot to the hot water faucet. Screw
on coupling by hand until it is seated on the washer.
3. Attach the hose labeled cold to the cold water faucet. Screw
on coupling by hand until it is seated on the washer.
4. Using pliers, tighten the couplings with an additional
two-thirds turn.
Tighten the couplings
with an additional
two-thirds
turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Clear the water lines
•
Run water through both faucets and inlet hoses, into a
laundry tub, drainpipe or bucket, to get rid of particles in the
water lines that might clog the inlet valve screens.
•
Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold water hose is connected to the cold water faucet.
Connect the inlet hoses to the washer
A
COLD
B
A. Hot water inlet valve
B. Cold water inlet valve
1. Attach the hot water hose to the inlet valve labeled hot.
2. Attaching one hose coupling first makes it easier to tighten
the connection with pliers.
8