Whirlpool 27' 취업 지원 - 페이지 19

{카테고리_이름} Whirlpool 27'에 대한 취업 지원을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 27' 36 페이지. Microwave oven and thermal oven
Whirlpool 27'에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (48 페이지), 설치 지침 매뉴얼 (22 페이지), 설치 지침 매뉴얼 (27 페이지), 설치 지침 매뉴얼 (32 페이지), 설치 지침 매뉴얼 (12 페이지), 설치 지침 (5 페이지)

Removing the Timer

1. Pull the timer knob off the timer assembly shaft.

2. Tip the console into the service position.

3. Disconnect the wiring harness connectors from the timer assembly terminals.

4. Remove the two (2) screws securing the timer assembly mounting bracket to the console.

1. Tip the console into the service position.

2. Disconnect the wiring harness leads from the

terminals on the switch assembly.

3. Press in on the snap tabs as indicated in Fig. 14

and then pull the bottom of the switch assembly

out from the console.

4. Slide the top of the switch assembly down until the

ears clear the console and remove the switch

assembly.

Removing the Push to Start Switch

1. Pull the knob off the Push-to-Start switch shaft.

2. Tip the console into the service position.

3. Disconnect the wiring harness leads from the Push-to-Start switch terminals.

4. Remove the two (2) screws securing the Push-to-Start switch to the console and remove the

switch.

1. Tip the console into the service position.

2. Disconnect the wiring harness heads from the buzzer terminals.

3. Remove the two (2) screws securing the buzzer to the console and remove the buzzer.

1. Tip the console into the service position.

2. Disconnect the wiring harness heads from the control board terminals.

3. Pull the control board from the mounting bracket.

1. Remove the console.

2. Remove the three screws at the back

of the dryer top. (Fig. 15)

3. Slide top toward you to release top from front

clips and rear tabs. (Fig. 16)

4. Lift top up and off dryer.

PUSH IN

Mounting "EARS"

Snap Tabs

PUSH IN

Fig. 14

Fig. 15