Whirlpool 27' 설치 지침 매뉴얼 - 페이지 14

{카테고리_이름} Whirlpool 27'에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 27' 27 페이지. Microwave oven and thermal oven
Whirlpool 27'에 대해서도 마찬가지입니다: 취업 지원 (36 페이지), 설치 지침 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (48 페이지), 설치 지침 매뉴얼 (22 페이지), 설치 지침 매뉴얼 (32 페이지), 설치 지침 매뉴얼 (12 페이지), 설치 지침 (5 페이지)

Direct Wire Connection

Direct Wire Strain Relief

Attach direct wire strain relief

Unscrew the removable conduit connector (A) and any

screws from a 3/4" (19 mm) UL listed strain relief (UL marking

on strain relief). Put the threaded section of the strain relief

Reaching inside the terminal block opening, screw the

removable conduit connector (A) onto the strain relief threads.

Attach direct wire cable to strain relief

Put direct wire cable through the strain relief. The strain

relief should have a tight fit with the dryer cabinet and be in

a horizontal position. Tighten strain relief screw against the

direct wire cable.

If your wiring looks like this:

4-wire direct connection:

Go to "4-Wire Direct Connection" on

this page.

3-wire direct connection:

Go to "3-Wire Direct Connection" on

page 15.

4-Wire Direct Wire Connection

IMPORTANT:

homes and where local codes do not permit 3-wire

connections.

Prepare your 4-wire cable for direct

connection

Direct wire cable must have 5 ft. (1.52 m) of extra length so

washer/dryer may be moved if needed.

Strip 5" (127 mm) of outer covering from end of cable,

leaving bare ground wire at 5" (127 mm). Cut 1

from remaining 3 wires. Strip insulation back 1" (25 mm).

Shape ends of wires into hooks.

Prepare to connect neutral ground

wire and neutral wire

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

A 4-wire connection is required for mobile

" (38 mm)