Whirlpool 27' Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Suszarka Whirlpool 27'. Whirlpool 27' 27 stron. Microwave oven and thermal oven
Również dla Whirlpool 27': Pomoc w pracy (36 strony), Instrukcja instalacji (11 strony), Instrukcja instalacji (11 strony), Instrukcja instalacji (48 strony), Instrukcja instalacji (22 strony), Instrukcja instalacji (32 strony), Instrukcja instalacji (12 strony), Instrukcje instalacji (5 strony)

Direct Wire Connection

Direct Wire Strain Relief

Attach direct wire strain relief

Unscrew the removable conduit connector (A) and any

screws from a 3/4" (19 mm) UL listed strain relief (UL marking

on strain relief). Put the threaded section of the strain relief

Reaching inside the terminal block opening, screw the

removable conduit connector (A) onto the strain relief threads.

Attach direct wire cable to strain relief

Put direct wire cable through the strain relief. The strain

relief should have a tight fit with the dryer cabinet and be in

a horizontal position. Tighten strain relief screw against the

direct wire cable.

If your wiring looks like this:

4-wire direct connection:

Go to "4-Wire Direct Connection" on

this page.

3-wire direct connection:

Go to "3-Wire Direct Connection" on

page 15.

4-Wire Direct Wire Connection

IMPORTANT:

homes and where local codes do not permit 3-wire

connections.

Prepare your 4-wire cable for direct

connection

Direct wire cable must have 5 ft. (1.52 m) of extra length so

washer/dryer may be moved if needed.

Strip 5" (127 mm) of outer covering from end of cable,

leaving bare ground wire at 5" (127 mm). Cut 1

from remaining 3 wires. Strip insulation back 1" (25 mm).

Shape ends of wires into hooks.

Prepare to connect neutral ground

wire and neutral wire

Remove center terminal block screw (B). Remove neutral

ground wire (E) from external ground conductor screw (A).

A 4-wire connection is required for mobile

" (38 mm)