Whirlpool 3LCED9100 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Whirlpool 3LCED9100에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3LCED9100 48 페이지. Commercial he dryer
Whirlpool 3LCED9100에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (48 페이지), 사용자 지침 (5 페이지)
페이지 인쇄
Product
Dimensions
686 mm (27"} dryer
T
965 mm
(33=. )
25 rein
(1")
686 mm
127. _
B
FRONT VIEW
i i:
ELECTRIC
102mm (4")
dia.
-,_358 mm_.._
(14")
BACK VIEW
t
715 mm
203 mm
(8")
921 mm
(36i/4")
25 mm
(1")
736 mm
(29") 695 mm
'1,- .......
r
I
!
e
SIDE VIEW
This dryer is supplied without an electric cord and plug. It must
be connected by a competent
electrician to a single-phase
electricity supply at the voltage shown on the dataplate, using a
suitable fixed wiring installation in accordance with local and
national wiring regulations.
[]
A 3-wire circular cord of minimum conconductor
size 2.5 mm2
cross-section
area should be used.
[]
A 30A supply fuse should be used, and a switch having
a contact separation in both poles that provides full
disconnection
under over-voltage category Ill conditions
must be incorporated into the fixed wiring in accordance with
local wiring regulations. The dryer should be positioned so
that the disconnection
switch is easily accessible to the user.
[]
A cord clamp bush is provided on the dryer, and should be
tightened on completion of wiring. The electrical mains
terminals are located behind the small rear access panel
(terminal block cover), and connections should be made in
accordance with the terminal markings. Remember to replace
the terminal access panel (terminal block cover).
NOTE: In accordance
with the European EMC Directive
(2004/108/EC),
the maximum electricity
supply system
impedance to which the electric dryer should be connected
is declared to be 0.29 Ohm + j0.18 Ohm.
Electric
Shock Hazard
This is a 3-wire appliance
which must be earthed.
Do not earth to a gas pipe.
Failure to follow these instructions could result in
death, fire, or serious injury.
If codes permit and an additional earth bond wire is used, it is
recommended that a qualified electrician determine that the earth
bond path is adequate.
Recommended
Earthing
Method
[]
It is your responsibility to contact a qualified electrical installer
to ensure that the electrical installation is adequate and in
conformance
with all local codes and ordinances.
5