Whirlpool 3LWED4830FW 설치 지침 매뉴얼 - 페이지 14

{카테고리_이름} Whirlpool 3LWED4830FW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3LWED4830FW 19 페이지. 737 mm (29 inch) wide models – gas & electric

CONNECT VENT

Connect vent to exhaust outlet

Using a 102 mm (4") clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 102 mm (4") clamp.

Move dryer to final location

Move dryer to final location. Avoid crushing or kinking vent.

After dryer is in place, remove corner posts and cardboard

from under the dryer.

LEVEL DRYER

Level dryer

Check levelness of dryer from side to side. Repeat from

front to back.

NOTE: The dryer must be level for the moisture sensing system

to operate correctly.

Not Level

Tighten and adjust leveling legs

If dryer is not level or the same height as the washer, prop up

using a wood block. Use wrench to adjust legs up or down

and check again for levelness. Once legs are level, make sure

all four legs are snug against the floor before tightening them.

LEVEL

Not Level