Whirlpool 3LWED4830FW 설치 지침 매뉴얼 - 페이지 15

{카테고리_이름} Whirlpool 3LWED4830FW에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3LWED4830FW 19 페이지. 737 mm (29 inch) wide models – gas & electric

페이지 인쇄

POWER CORD INSTALLATION

(on some models)

IMPORTANT: To be performed by Whilrpool Corporation

authorized service personnel only.

Select plug

Select the plug that fits with the electric receptacle.

NOTE: Plug types and quantities will vary by model.

Assemble plug

Assemble the plug into the end of the power cord located on

the back of the dryer.

Secure power cord

Secure the power cord by seating the connection on the cord

lock. Place the cord lock cover and push until it snaps. Make

sure the power cord connection is seated on the cord lock

and that the cord lock clamps correctly.

Plug power supply cord into an earthed outlet. Turn power

supply on.

COMPLETE INSTALLATION

CHECKLIST

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Check dryer's final location. Be sure vent is not crushed

or kinked.

Check that dryer is level. See "Level Dryer."

Remove film on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth

to remove any dust.

Read "Dryer Use" in your Use and Care Guide.

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

If the dryer will not start, check the following:

nDryer is plugged into an earthed 3-prong outlet.

nElectrical supply is connected.

n H ousehold fuse is intact and tight, or circuit breaker has

not tripped.

nDryer door is closed.

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle

and close the door.

If you do not feel heat, turn the dryer off and check to see

whether gas supply line shut-off valve is open.

n I f the gas supply line shut-off valve is closed, open it,

then repeat the 5-minute test as outlined above.

n I f the gas supply line shut-off valve is open, contact

a qualified technician.

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used.

The odor will go away.