Whirlpool 3SWED5205SQ1 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool 3SWED5205SQ1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3SWED5205SQ1 24 페이지. Electronic dryer

This dryer is equipped with a power supply cord. To minimize

■

possible shock hazard, the cord must be plugged into a

mating wall receptacle. See Figures 1 & 2.

If your electrical requirements are different, contact your

■

authorized Whirlpool service center or a qualified electrician.

two-wire

receptacle

Figure 1

Direct Wire

It is recommended that installation should be done by a

■

qualified electrician.

This dryer can be connected directly to the fused disconnect

■

or circuit breaker box with two-wire or three-wire flexible,

armored or non-metallic sheathed copper cable (with ground

wire). Do Not use two-wire with bare ground wire. All

current-carrying wires must be insulated.

A conduit connector must be installed at each end of the

■

power supply cable (at the dryer and at the junction box.)

USE ONLY 10-GAUGE SOLID COPPER WIRE. DO NOT USE

ALUMINUM WIRE. Allow 4 ft (1.22 m) of slack in the line so

the dryer can be moved if servicing is ever necessary.

Recommended Ground Method

It is your responsibility to contact a qualified electrical

■

installer to ensure that the electrical installation is adequate

and in conformance with the National Electrical Code, ANSI/

NFPA 70, latest edition, and all local codes and ordinances.

ring

terminals

ground

wire

strain

relief

three-wire

power supply cord

Figure 2

Electrical Connection

Two-Wire Connection

Plug power supply cord into the grounded outlet or connect

direct wire to power supply. Turn power supply on.