Whirlpool 3SWED5205SQ1 Kullanım ve Bakım Kılavuzu - Sayfa 13
Kurutucu Whirlpool 3SWED5205SQ1 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool 3SWED5205SQ1 24 sayfaları. Electronic dryer
Sayfayı Yazdır
This dryer is equipped with a power supply cord. To minimize
■
possible shock hazard, the cord must be plugged into a
mating wall receptacle. See Figures 1 & 2.
If your electrical requirements are different, contact your
■
authorized Whirlpool service center or a qualified electrician.
two-wire
receptacle
Figure 1
Direct Wire
It is recommended that installation should be done by a
■
qualified electrician.
This dryer can be connected directly to the fused disconnect
■
or circuit breaker box with two-wire or three-wire flexible,
armored or non-metallic sheathed copper cable (with ground
wire). Do Not use two-wire with bare ground wire. All
current-carrying wires must be insulated.
A conduit connector must be installed at each end of the
■
power supply cable (at the dryer and at the junction box.)
USE ONLY 10-GAUGE SOLID COPPER WIRE. DO NOT USE
ALUMINUM WIRE. Allow 4 ft (1.22 m) of slack in the line so
the dryer can be moved if servicing is ever necessary.
Recommended Ground Method
It is your responsibility to contact a qualified electrical
■
installer to ensure that the electrical installation is adequate
and in conformance with the National Electrical Code, ANSI/
NFPA 70, latest edition, and all local codes and ordinances.
ring
terminals
ground
wire
strain
relief
three-wire
power supply cord
Figure 2
Electrical Connection
Two-Wire Connection
Plug power supply cord into the grounded outlet or connect
direct wire to power supply. Turn power supply on.
13