Whirlpool 3SWED5205SQ1 사용 및 관리 매뉴얼 - 페이지 18

{카테고리_이름} Whirlpool 3SWED5205SQ1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3SWED5205SQ1 24 페이지. Electronic dryer

Connect Vent

Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and

inside exhaust hood. Check that vent is secured to exhaust

hood with a 4" (102 mm) clamp.

Move dryer to final location

Move dryer to final location. Avoid crushing or kinking vent.

After dryer is in place, remove corner posts and cardboard

from under the dryer.

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that dryer is level. See "Level Dryer".

Check that you have all of your tools.

For power supply cord installation, plug into an outlet.

For direct wire installation, turn on power.

Read "Dryer Use" in your Use and Care Guide.

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

If the dryer will not start, check the following:

Dryer is plugged into an outlet and/or electrical supply

■

is on.

Household fuse is intact and tight, or circuit breaker has

■

not tripped.

Dryer door is closed.

■

Controls are set in a running or "On" position.

■

Start button has been pushed firmly.

■

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used.

The odor will go away.

Reverse Door Swing (Optional)

Super wide-swing door model shown.

Place towel on dryer

Place towel on top of dryer to avoid damaging the surface.

NOTE: Magnetized screw driver is helpful.