Whirlpool 3SWED5205SQ1 Gebruiks- en onderhoudshandleiding - Pagina 18
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Whirlpool 3SWED5205SQ1. Whirlpool 3SWED5205SQ1 24 pagina's. Electronic dryer
Pagina afdrukken
Connect Vent
1.
Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and
inside exhaust hood. Check that vent is secured to exhaust
hood with a 4" (102 mm) clamp.
2.
Move dryer to final location
Move dryer to final location. Avoid crushing or kinking vent.
After dryer is in place, remove corner posts and cardboard
from under the dryer.
18
Complete Installation Checklist
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that dryer is level. See "Level Dryer".
q
Check that you have all of your tools.
q
For power supply cord installation, plug into an outlet.
For direct wire installation, turn on power.
Read "Dryer Use" in your Use and Care Guide.
q
q
Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
Dryer is plugged into an outlet and/or electrical supply
■
is on.
Household fuse is intact and tight, or circuit breaker has
■
not tripped.
Dryer door is closed.
■
Controls are set in a running or "On" position.
■
Start button has been pushed firmly.
■
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.
Reverse Door Swing (Optional)
Super wide-swing door model shown.
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
NOTE: Magnetized screw driver is helpful.