Whirlpool AZA-HP 7572 빠른 참조 매뉴얼 - 페이지 3

{카테고리_이름} Whirlpool AZA-HP 7572에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AZA-HP 7572 5 페이지.

페이지 인쇄

...you want to check the dryer yourself first: (If your machine is not functioning correctly, please check the

following points before calling the customer service – also refer to relevant chapter in the Instructions for use)

Drying takes too long /

Laundry is not dry

enough

The dryer does not

operate (after a power

failure, always press

the "Start (Pause)"

button)

Filter, water container

indicator lamp on

Water droplets

underneath the dryer

...you want to care of and clean your dryer:

Clean the filter at the

end of every cycle

Empty the water

container at the end of

every drying cycle

Clean the bottom filter

every fifth cycle

HOW TO PROCEED IF...

• Has the correct drying programme been selected?

• Has the cycle been interrupted (door opening, full water container)?

• Was the inserted laundry too wet (washing machine spin speed less

than 1000 rpm)?

• Is the lint filter dirty (filter indicator light on)?

• Is the heat exchanger dirty (for more information, refer to the

Instructions for use)?

• Is the room temperature too high?

• Is the "End" and "Anticrease" indicator lamp lighting up?

The drying cycle is complete and the laundry can be taken out.

• If the drying result does not meet your expectation, select a more dry

programme or use the dryness adjustment option (if available) to

optimize the drying result.

• Is the plug properly inserted into the mains electricity socket?

• Is there a power failure?

• Has the fuse blown?

• Is the door properly closed?

• Has a drying programme been selected?

• Has the "Start (Pause)" button been pressed?

• Has the start delay option been selected?

• Is the dryer overloaded?  Please remove a part of the load.

• Is the lint filter clean?

• Is the water container empty?

• Has the water container been inserted correctly?

• Is the heat exchanger clean and inserted correctly?

• Has the heat exchanger been inserted correctly?

• Have all lint on the heat exchanger seal and the door seal been

wiped away?

• Has the water container been inserted correctly?

• If the direct drain connection is used, is it tight?

• Is the dryer leveled?

• Brush lint using a soft brush or your fingertips.

• Close the filter.

• Push the filter back into place.

• Pull the handle to remove the water container.

• Empty the water container.

• Replace the water container when empty by pushing it completely

back into place.

• Clean the bottom filter under running water.

• Remove all fluffs from the seals.

• Clean the heat exchanger housing (for further information see

chapter "Cleaning the heat exchanger" in the Instructions for use).

• See the Instruction for use for further information how to clean the

bottom filter.