Whirlpool CABRIO WED8200YW2 사용 및 관리 매뉴얼 - 페이지 15

{카테고리_이름} Whirlpool CABRIO WED8200YW2에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CABRIO WED8200YW2 36 페이지. Electronic dryer

페이지 인쇄

First try the solutions suggested here or visit our website at www.whirlpool.com/help

for assistance and to possibly avoid a service call.

If you experience

Odors

Recent painting, staining, or

varnishing in the area where your

dryer is located.

For Steam Cycles, the water is not

properly connected with the dryer.

Odors are left in garments after

wearing.

Ventilate the area. When the odors or fumes are gone from the

area, rewash and dry the clothing.

Make sure water is connected to the dryer. Check that water

inlet hose is connected to both the faucet and dryer's water

inlet valve. Check that the water supply is turned on.

To remove odors left in garments after wearing, select Enhanced

Touch Up or Quick Refresh (on some models). These cycles are

best for reducing wrinkles and odors from loads consisting

wrinkle-free

cotton, cotton polyester blends, common knits,

and synthetics.

Load too hot

Allow the dryer to complete the cool down portion of the cycle

before removing the load.

Load removed before cool down

portion of cycle complete.

Using Timed Dry Cycle with a high

temperature

setting.

Select an Automatic

cycle with a lower heat setting to avoid

overdrying the load.

"PF" (power failure)

"L2" Diagnostic Code

(low or no line voltage

condition)

"F# E#" (F1 El, F3 El, etc.)

variable service codes.

The drying cycle has been

interrupted by a power failure.

There may be a problem with your

home power supply keeping the

dryer's heater from turning on.

The dryer is in need of service.

Press START/PAUSE twice to resume the cycle, or press

POWER to select a new cycle.

The dryer will continue to run when this diagnostic code

is present. Press any key to clear the code from the display

and return to the estimated time remaining.

Try the following:

Check to see if a household fuse has blown or circuit

breaker has tripped. Electric dryers use two household fuses

or breakers. Replace the fuse or reset the circuit breaker.

Confirm the power cord is properly installed. Refer to

"hstallation

hstructions"

for details.

Select a Timed Dry heated cycle, and restart the dryer.

Hfthe message persists, consult a qualified electrician.

Hfa code beginning with an "F" appears in the display.

Alternating

between F# and E#, the dryer control has

detected a problem that requires service. Call for service.