Whirlpool CEM2743BQ 설치 지침 매뉴얼 - 페이지 21
{카테고리_이름} Whirlpool CEM2743BQ에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CEM2743BQ 48 페이지. Commercial dryer gas or electric
Whirlpool CEM2743BQ에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (48 페이지)
페이지 인쇄
ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connecting 4-Wire Connection: Direct Wire
Connecting Neutral Ground and Neutral Wires (cont.)
2. Connect neutral ground wire (B) and place hooked end (hook
facing right) of neutral wire (white or center wire) (D) of direct
wire cable under center terminal block screw (A). Squeeze
hooked ends together and tighten screw.
B
D
Connecting Direct Wire Ground
3. Connect ground wire (green or bare wire) (E) of direct wire
cable under green external ground conductor screw (C).
Tighten screw.
E
C
Connecting 3-Wire Connection: Direct Wire
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
Direct wire cable must have 5 ft. (1.52 m) of extra length so
dryer can be moved if needed.
Strip 3
⁄
" (89 mm) of outer covering from end of cable. Strip
1
2
insulation back 1" (25 mm). If using 3-wire cable with ground
wire, cut bare wire even with outer covering. Shape ends of
wires into a hook shape.
Connecting Neutral Wire
1. Loosen or remove center terminal block screw (A).
Connecting Remaining Wires
4. Connect remaining wires under outer terminal block screws
(F). Squeeze hooked ends together and tighten screws.
A
2. Place hooked end of neutral wire (white or center wire) (D)
of direct wire cable under center terminal block screw (A),
hook facing right. Squeeze hooked end together and tighten
screw.
D
A
3. Connect remaining wires under outer terminal block screws
(F). Squeeze hooked ends together and tighten screws.
Finally, reinstall terminal block to dryer rear panel. Secure
cover with hold-down screw.
(FOR U.S.A. ONLY)
F
F
A
F
F
21