Whirlpool Duet WED9150WW0 설치 지침 매뉴얼 - 페이지 11

{카테고리_이름} Whirlpool Duet WED9150WW0에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool Duet WED9150WW0 16 페이지. 27" electric dryer
Whirlpool Duet WED9150WW0에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (25 페이지)

페이지 인쇄

Place hooked e nds ofremaining wires u nder o uter t erminal block

screws ( hooks f acing right). Tighten s crews.

24,

Connect external

ground

wit

Connect external ground wire to the green ground terminal

screw. Finally, reinsert tab of terminal block cover into slot of

dryer rear panel. Secure cover with hold-down screw. Now, go

to Venting Requirements.

¥%NTING

REQUIREMENTS

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent,

Failure to follow these instructions can result in death

or fire.

WARNING:

To reduce the risk of fire, this dryer MUST BE

EXHAUSTED OUTDOORS.

IMPORTANT:

Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, attic, crawlspace,

or a concealed space

of a building. Only rigid or flexible metal vent shall be used for

exhausting.

[] Only a 4" (102 mm) heavy metal exhaust

vent and clamps may be used.

[] Do not use plastic or metal foil vent.

Rigid metal

vent:

[] Recommended

for best drying performance

and to prevent

crushing and kinking.

Flexible

metal

vent:

(Acceptable only if accessible to clean)

[] Must be fully extended and supported

in final dryer location.

[] Remove excess to avoid sagging and kinking that may result

in reduced airflow and poor performance.

[] Do not install in enclosed walls, ceilings, or floors.

[] The total length should not exceed 7 3/4ft. (2.4 m).

NOTE:

If using an existing vent system, clean lint from entire

length of the system and make sure exhaust hood is not plugged

with lint. Replace plastic or metal foil vents with rigid metal or

flexible metal vents. Review Vent system chart and if necessary,

modify existing vent system to achieve best drying performance.

Exhaust

hoods:

[] Must be at least 12" (305 mm) from ground or any object that

may obstruct exhaust (such as flowers, rocks, bushes, or

snow).

(102m

1_4.4%

(102 ram)

Recommended

styles:

Acceptable

styles:

A. Louvered hood

C. Angled hood

B. Box hood

[] An exhaust hood should cap vent to keep rodents and insects

from entering home.

[] Do not use exhaust hood with a magnetic latch.