Whirlpool WGD9151YW 설치 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool WGD9151YW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9151YW 36 페이지. Installation guide
Whirlpool WGD9151YW에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사용 설명서 (8 페이지), 사용 및 관리 매뉴얼 (40 페이지)

페이지 인쇄

Determine vent path:

■

Select route that will provide straightest and most direct

path outdoors.

■

Plan installation to use fewest number of elbows and turns.

■

When using elbows or making turns, allow as much room

as possible.

■

Bend vent gradually to avoid kinking.

■

Use as few 90° turns as possible.

Determine vent length and elbows needed for best

drying performance:

■

Use the following Vent System Chart to determine type of vent

material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified

in Vent system chart.

Exhaust systems longer than those specified will:

■

Shorten life of dryer.

■

Reduce performance, resulting in longer drying times

and increased energy usage.

The Vent System Chart provides venting requirements that will

help achieve best drying performance.

NOTE: Side and bottom exhaust installation have a 90° turn

inside the dryer. To determine maximum exhaust length, add one

90° turn to the chart.

Vent System Chart

Number of

Type

90° elbows

of vent

Rigid metal

Box/louvered

Angled

hoods

64 ft. (20 m)

58 ft. (17.7 m)

54 ft. (16.5 m)

48 ft. (14.6 m)

44 ft. (13.4 m)

38 ft. (11.6 m)

35 ft. (10.7 m)

29 ft. (8.8 m)

27 ft. (8.2 m)

21 ft. (6.4 m)

Install Vent System

Install exhaust hood

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

Connect vent to exhaust hood

Vent must fit over the exhaust hood. Secure vent to exhaust

hood with 4" (102 mm) clamp. Run vent to dryer location using

straightest path possible. Avoid 90° turns. Use clamps to seal

all joints. Do not use duct tape, screws, or other fastening

devices that extend into interior of vent to secure vent,

because they can catch lint.

12" min.

(305 mm)

12" min.

(305 mm)