Whirlpool WGD9151YW 설치 매뉴얼 - 페이지 15

{카테고리_이름} Whirlpool WGD9151YW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9151YW 36 페이지. Installation guide
Whirlpool WGD9151YW에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사용 설명서 (8 페이지), 사용 및 관리 매뉴얼 (40 페이지)

페이지 인쇄

Attach long hose to dryer fill valve

and tighten coupling

Remove protective cap from

water inlet valve. Attach other end

of long hose to fill valve at bottom of dryer back panel.

Screw on coupling by hand until it is seated on fill valve

connector. Using pliers, tighten the couplings an additional

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling

can result.

Turn on cold water faucet

Check that the water faucets are turned on.

Check for leaks

Check for leaks around "Y" connector, faucet, and hoses.

CONNECT VENT

Connect vent to exhaust outlet

Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure vent is

clean. Dryer vent must fit over dryer exhaust outlet and inside

exhaust hood. Check that vent is secured to exhaust hood

with a 4" (102 mm) clamp.

Move dryer to final location

Move dryer to final location, taking care not to crush or

kink vent or flexible gas line.

After dryer is in place, remove corner posts and cardboard

from under dryer.