Whirlpool WGD9400SW1 사용 및 관리 매뉴얼 - 페이지 14

{카테고리_이름} Whirlpool WGD9400SW1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WGD9400SW1 48 페이지. Electronic gas dryer
Whirlpool WGD9400SW1에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (32 페이지)

페이지 인쇄

DRYER USE

Explosion Hazard

Keep flammable

materials

and vapors, such as

gasoline,

away from dryer.

Do not dry anything

that has ever had anything

flammable

on it (even after washing).

Failure to follow

these instructions can result in death,

explosion,

or fire.

Fire Hazard

No washer can completely remove oil.

Do not dry anything that has ever had any type of oil on

it (including cooking oils).

items containing foam, rubber, or plastic must be dried

on a clothesline or by using an Air Cycle.

Failure to follow

these instructions can result in death

or fire.

This manual covers several different models. Your dryer may not

have all of the cycles and features described.

The following is a guide to starting your dryer. Please refer to

specific sections of this manual for more detailed information.

1. Clean lint screen before each load. See "Cleaning the Lint

Screen."

2. Place laundry in dryer and shut door.

3. Press the POWER button then rotate the dial to select either

an Automatic or Manual Cycle. The preset settings and drying

time for the cycle chosen will be displayed.

NOTE: A default time is displayed when an Automatic Cycle

is selected. During the first few minutes of the drying process,

the cycle time may automatically vary from the default time

based on the size and fabric type of the load. Toward the end

of the drying process, the estimated time display will adjust

again, showing the final drying time.

To use an Automatic Cycle

NOTE: A light next to each feature will glow green when the

feature is selected or will glow amber when the feature is

selectable. The light will not glow when the selection is

unavailable with the cycle or option combinations

selected.

•

Press the POWER button.

•

Rotate the dial to select an Automatic

Cycle.

Select DRYNESS LEVEL to adjust how dry you want the

load to be. As the cycle runs, the control senses the

dryness of the load and adjusts the time automatically

for

the selected Dryness Level.

NOTE: Most loads may be dried using Normal, which is

shown in bold letters on your control panel. Normal is the

energy preferred dryness level and will use the least

energy.

Normal

Less

The default dryness setting is Normal when an Auto Dry

Cycle is selected. You can select a different dryness level,

depending on your load, by pressing DRYNESS LEVEL

and choosing More, Normal or Less. Selecting More,

Normal or Less automatically

adjusts the dryness level at

which the dryer will shut off. Once a dryness level is set, it

cannot be changed without stopping the cycle.

The Dryness Level can be changed only with Automatic

Cycles.

Press the WRINKLE SHIELD

feature button if this

option is desired.

Press the CYCLE SIGNAL button to set end of cycle

signal volume to desired level.

Press the DAMP DRY CYCLE SIGNAL button to set damp

dry signal volume to desired level.