Whirlpool WHD5090GW 사용 및 관리 매뉴얼 - 페이지 14
{카테고리_이름} Whirlpool WHD5090GW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WHD5090GW 35 페이지. Heat pump dryer
페이지 인쇄
INSTALLATION INSTRUCTIONS
Installation Requirements
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver
Min. 8" long TORX
T20
®
®†
screwdriver
Wire stripper (direct wire
installations)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Utility knife
Level
14
#2 Phillips screwdriver
1/4" and 5/16" nut driver
(recommended)
Channel locks
Pliers
Tape measure
If using a power supply cord:
Use a UL-listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL-listed 30-amp power supply cord, rated 120-/240-volt
minimum. The cord should be type SRD or SRDT and
be at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
Additional Accessories:
Refer to "Operating Instructions" for information about
accessories available for your dryer.
†® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
(Not supplied with dryer)