Whirlpool AKR473.1/IX 건강 및 안전, 사용 및 관리, 설치 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool AKR473.1/IX에 대한 건강 및 안전, 사용 및 관리, 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AKR473.1/IX 15 페이지.

DESCRIPTION AND USE OF HOOD

1. Control panel.

2. Grease filter.

3. Grease filter spring release handles.

4. Lighting.

5. Pull-out steam deflector.

6. Extractor unit body.

Control panel

1. Light ON/OFF button

2. Timer ON/OFF button: time-delayed switch-off of the selected extraction speed (power):

Extraction speed (power) 1: 20 minutes

Extraction speed (power) 2: 15 minutes

Extraction speed (power) 3: 10 minutes

Intensive extraction speed (power): 5 minutes.

3. OFF / Extraction speed (power) decrease button

4. ON / Extraction speed (power) increase button

5. Display, shows:

a. Extraction speed (power): LEDs L1 - L2 - L3 - L4 (flashing) light up according to the selected

extraction speed (power).

Note: LED L4 - intensive extraction speed (power) works for approximately 5 minutes after which

the hood sets the intermediate speed.

b. Timer: The LED of the selected speed will flash to indicate that the timer is active.

c. Grease filter saturation: LEDs L3 and L4 flash alternately with a short time interval.

d. Active carbon filter saturation: LEDs L3 and L4 flash at the same time with a short time

interval.

Filter saturation signaling reset: Carry out filter maintenance, then press and hold button 2 until

the LEDs go out.

Note: Active carbon filter saturation is normally disabled and should only be activated if the hood is

used as a filter version (with carbon filter fitted).

To do so, proceed as follows:

- switch off the hood

- press and hold both buttons 3 and 4 until LEDs L1 and L2 briefly flash.

To turn off repeat this process, only LED L1 will briefly flash.

GB14