Whirlpool AKR601UMIX 설치, 사용 및 관리 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool AKR601UMIX에 대한 설치, 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AKR601UMIX 12 페이지.
Whirlpool AKR601UMIX에 대해서도 마찬가지입니다: 사용 설명서 지침 (47 페이지)

페이지 인쇄

CONTROL PANEL

A. Light switch.

B. Speed selector switch.

REPLACING BULBS:

1. Disconnect power.

WARNING: Wear gloves.

2. Remove the grease filter support grille (Fig. 2) or the grease filter

to access the lamp housing (Fig. 1). On some models the lamp

cover can simply be prised off using standard screwdriver

(A - Fig. 1).

3. Remove the burnt-out bulb.

Replace using 40 W max E14 bulbs only.

4. Refit the extractor grille or lighting unit.

WARNING: Disconnect the hood from the mains supply

before carrying out this procedure.

REMOVING AND REPLACING OR CLEANING

THE GREASE FILTER:

Grease filter - it can be one of the following types:

Paper filter: to be replaced once a month or, if the top part is

coloured, when the colour shows through the holes in the grille.

Metal filter: to be washed once a month by hand or in a dishwasher

with quick wash cycle at low temperature.

Note: The metal filter may become opaque over time; this does not

affect its filtering capacity.

1. Disconnect power.

2. Remove the extractor grilles or the grease filters - using parts L or

N, (Fig. 1).

3. Release the grease filter (selected models - Fig. 3).

4. Remove the dirty grease filter.

5. After the grease filter has been replaced or cleaned (depending on

model), refit the parts in reverse order, making sure the entire

extraction surface is covered.

FITTING OR REPLACING THE CARBON FILTER:

Fitting or replacing the carbon filter (filter hoods only):

Change the carbon filter every four months.

It cannot be washed or regenerated.

1. Disconnect power.

2. Remove the extractor grilles or the grease filters (Fig. 1) or the

surround (Fig. 2).

3. Rectangular filter: position the filter A so that it covers the motor

protection grille and turn the knob clockwise. To release,

proceed in reverse order.

Round filter: Insert the carbon filter over the motor protection

grille, on some models the reference mark B must line up with

the arrow C printed on the fan shroud; next, turn clockwise.

4. To remove the filter, turn the filter or knob anti-clockwise.

5. Refit the grille, the filter or the grease filter surround.

-Change the carbon filter every four months.

PRODUCT SHEET

Fig. 2

Fig. 1

Fig. 3

Fig. 4