Whirlpool RH8930XLS 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool RH8930XLS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool RH8930XLS 8 페이지. Vented kitchen range hood for 120 v. operation

페이지 인쇄

TROUBLE

SHOOTING

PROCEDURE

lf entire

unit is not working,

proceed

as follows:

Check

circuit

breaker

box to insure

that breaker

for hood is not tripped.

Remove

printed

circuit

board enclosure

cover

by removing

two screws

securing

the cover.

(See Figure

I .)

CAUTION:

SHOCK

HAZARD

SOME CIRCUIT

BOARD COMPONENTS

(INCLUDING

HEAT SINKS) ARE NOT ISOLATED

FROM

THE AC POWER LINE.

Disengage

five pin connector

from P. C. board

and check

for 115VAC

(nominal)

AC line voltage

between

the black

wire socket

(end socket)

and white

wire socket

(center

socket)

by inserting

VOM probes

into sockets.

If voltage

is not present,

proceed

as follows:

Turn off power

at breaker

box.

Check

connections

in rear power

entry

box. (See Fig. 1.)

(1) Push in filter

retainmg

tabs and remove

filter from wiring

compartment.

(2) Remove

cover

retaining

screws

and cover.

(3) Remove

wiring

box covers

(2).

Check

continuity

of wires

from wire nut connections

to P. C. board sockets

by inserting

one

meter probe

in wire nut connection

and the other

probe

in respective

socket

connector.

Repair

or replace

as required,

restore

power

to unit and again check

for voltage

at P. C. board

connector.

If the fan or light still does not operate,

proceed

as follows:

With five pin connector

plugged

into board and light and/or

fan turned

on, check output

of the

red (light)

and blue (fan) wires

in the five pin connector

by inserting

one probe of the meter in

the backof

thesocket

at therespectivewireconnection

(redor

blue) andtheotherprobein

the

back of the socket

at the black wire connection.

(1)

Reading

for red wire output

should

be 50-65 VAC if the light is on "Lo" or loo-125

VAC if

the light is on "Hi".

(2)

Reading

for blue wire output

should

be between

72 VAC and the line voltage

reading,

depending

upon fan speed setting.

If output

readings

are correct,

problem

is in the wiring

from plug to devices

(fan and light) or in

the devices

themselves.

(Bad socket

or bulb and/or

defective

fan motor.)

If outputs

are not correct,

problem

is in the circuit

board or membrane

switch.

(See Page 2.)

CIRCUIT

BOARD

ENCLOSURE

COVER

MTG SCREWS (2),

FIVE PIN CONNECTOR

.y TRIM

RETAINING

SCREWS (41,

FILTER RETAINING

TABS (4) -J

COVER RETAINING

SCREWS (2)

A626-476

FIG. 1

INSIDE

OF HOOD

(1)

1-11-64