Whirlpool UXT2036AAB 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Whirlpool UXT2036AAB에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT2036AAB 8 페이지. Economy range hood

페이지 인쇄

iNSTALLiNG

WARNING

I TURN

OFF THE PROPER

CiRCUiT

AT THE SERVICE

ENTRANCE

BEFORE WiRiNG THiS RANGE HOOD.

1. Run electric wiring through hole drilled in wall or cabinet. Split

wiring for 6" and install proper connector for type of wire used.

(FIG. 9)

CONNECTOR

2. Position hood so that:

a.) Wiring is routed through knockout opening. (FIG. 10)

b.) Large part of keyhole slots fit over hood mounting screws.

(FIG. 10)

c.) Damper/duct

connector slides into ductwork.

(UXT3030AA, UXT3036AA, UXT4030AA, and UXT4036AA.

RANGE HOOD

6. Strip 1/2" of insulation foam wires. Connect white to white, black

to black, and green to prepared hole with green ground screw

provided. (FIG. 11)

I:!!

7. Replace wiring box cover and screw. Make sure that all wiring is

safely contained inside.

8. Install light (75 Watt maximum) For easier installation, squeeze

plastic lens and remove it from hood. Remember

to reinstall

lens (FIG. 12)

LIGHT

LENS

3. Adjust hood so that hood front is flush with cabinet frame.

4. Tighten hood mounting screws firmly.

5. Fasten wiring to hood with proper electrical connector for type

of wiring being used.

WARNING

ALL

ELECTRICAL

CONNECTIONS

MUST

ACCORDANCE

WITH LOCAL CODES, ORDINANCES,

NATIONAL ELECTRICAL

CODE. IF YOU ARE UNFAMILIAR

WITH METHODS

OF INSTALLING

ELECTRICAL

WIRING,

SECURE THE SERVICES

OF A QUALIFIED

ELECTRICIAN.

9. Turn on power and check operation of fan and light. Make sure

that damper operates freely.