Whirlpool UXT2036AAB Handleiding voor installatie-instructies - Pagina 5
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Whirlpool UXT2036AAB. Whirlpool UXT2036AAB 8 pagina's. Economy range hood
Pagina afdrukken
iNSTALLiNG
WARNING
i
I TURN
OFF THE PROPER
CiRCUiT
AT THE SERVICE
ENTRANCE
BEFORE WiRiNG THiS RANGE HOOD.
1. Run electric wiring through hole drilled in wall or cabinet. Split
wiring for 6" and install proper connector for type of wire used.
(FIG. 9)
CONNECTOR
2. Position hood so that:
a.) Wiring is routed through knockout opening. (FIG. 10)
b.) Large part of keyhole slots fit over hood mounting screws.
(FIG. 10)
c.) Damper/duct
connector slides into ductwork.
(UXT3030AA, UXT3036AA, UXT4030AA, and UXT4036AA.
RANGE HOOD
6. Strip 1/2" of insulation foam wires. Connect white to white, black
to black, and green to prepared hole with green ground screw
provided. (FIG. 11)
:
I:!!
7. Replace wiring box cover and screw. Make sure that all wiring is
safely contained inside.
8. Install light (75 Watt maximum) For easier installation, squeeze
plastic lens and remove it from hood. Remember
to reinstall
lens (FIG. 12)
LIGHT
LENS
3. Adjust hood so that hood front is flush with cabinet frame.
4. Tighten hood mounting screws firmly.
5. Fasten wiring to hood with proper electrical connector for type
of wiring being used.
WARNING
ALL
ELECTRICAL
CONNECTIONS
MUST
BE
IN
ACCORDANCE
WITH LOCAL CODES, ORDINANCES,
OR
NATIONAL ELECTRICAL
CODE. IF YOU ARE UNFAMILIAR
WITH METHODS
OF INSTALLING
ELECTRICAL
WIRING,
SECURE THE SERVICES
OF A QUALIFIED
ELECTRICIAN.
9. Turn on power and check operation of fan and light. Make sure
that damper operates freely.
5