Whirlpool UXT3030AY 설치 지침 및 사용 및 관리 매뉴얼 - 페이지 11

{카테고리_이름} Whirlpool UXT3030AY에 대한 설치 지침 및 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXT3030AY 28 페이지. 30" (76.2 cm) and 36" (91.4 cm) range hood
Whirlpool UXT3030AY에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 설명서 (32 페이지), 설치 지침 및 사용 및 관리 매뉴얼 (36 페이지)

페이지 인쇄

Complete Installation

1. Install the 75W (max.) Incandescent light bulb. See

"Replacing the Incandescent Light Bulb" in the "Range Hood

Care" section.

2. Replace grease filter if removed. See the "Range Hood Care"

section.

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

The hood controls are located on the top of the range hood.

A. Incandescent light housing and cover

B. Filter retainer

C. Grease filter

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filter

before operating hood.

Exterior Surfaces:

IMPORTANT: Do not use soap-filled scouring pads, abrasive

cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths

or paper towels.

To avoid damage to the stainless steel, do not use cleaners that

contain chlorine.

Cleaning Method:

Rub in direction of grain to avoid scratching or damaging the

surface.

For stainless steal models, Stainless Steel Cleaner and Polish

Part Number 31462A (not included): See "Assistance or

Service" section to order.

Liquid detergent or all-purpose cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

Glass cleaner to remove fingerprints.

RANGE HOOD USE

RANGE HOOD CARE

3. Check the operation of the range hood fan and light. See

"Range Hood Use" section.

If range hood does not operate, check to see whether a

circuit breaker has tripped or a household fuse has blown.

Disconnect power and check wiring connections.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.

Range Hood Controls

Operating the light

Push the light switch to the right to turn the light Off. Push the

light switch to the left to the turn the light On.

Operating the fan

Push the fan switch to the left for Low speed. Push the fan switch

to the right for High speed. Push the fan switch to the middle for

Off.

Cleaning

Metal Grease Filter

1. Remove screw from the grease filter retainer.

2. Turn the grease filter retainer to release filter.

3. Wash metal filters as needed in dishwasher or hot detergent

solution.

4. Reinstall the filter by placing the back edge in the channel at

rear of hood. Push filter into place, turn the filter retainer to

secure filter to range hood.

5. Replace screw in the grease filter retainer.

Off

Low

Off

A. On/Off light switch

B. Fan speed switch

A. Filter retainer

High