Whirlpool UXW7230BSS 설치 지침 및 사용 및 관리 설명서 - 페이지 9
{카테고리_이름} Whirlpool UXW7230BSS에 대한 설치 지침 및 사용 및 관리 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool UXW7230BSS 32 페이지. 30-inch vented 400-cfm wall-mount canopy hood
Whirlpool UXW7230BSS에 대해서도 마찬가지입니다: 설치 지침 및 사용 및 관리 설명서 (32 페이지), 설치 지침 및 사용 및 관리 설명서 (32 페이지)
페이지 인쇄
Install Range Hood
1. Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease filter. See "Range Hood Care" section.
3. Level the range hood and tighten upper mounting screws.
4. Install 2 - 5 x 45 mm lower mounting screws and tighten.
Connect Vent System
1. Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
For vented installations only:
1. Fit vent system over transition piece.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
For non-vented (recirculating) installations only:
1. Assemble the air deflector with the duct cover bracket with
B
C
2. Measure from the bottom of the air deflector to the bottom of
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over the exhaust
7. Reassemble the air deflector to the duct cover bracket with
8. Seal connections with vent clamps.
2 - assembly screws provided with the Recirculation Kit.
B
A. Vent cover bracket
B. 2.9 x 6.5 mm screws
C. Deflector
the hood outlet.
B
D
E
A. Air deflector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
outlet from the hood.
2 assembly screws.
A
B
C
A
C
X
9