Whirlpool UXW7230BSS Installation Instructions And Use And Care Manual - Page 9

Browse online or download pdf Installation Instructions And Use And Care Manual for Ventilation Hood Whirlpool UXW7230BSS. Whirlpool UXW7230BSS 32 pages. 30-inch vented 400-cfm wall-mount canopy hood
Also for Whirlpool UXW7230BSS: Installation Instructions And Use And Care Manual (32 pages), Installation Instructions And Use And Care Manual (32 pages)

Print Page

Install Range Hood

1. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

1. Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installations only:

1. Assemble the air deflector with the duct cover bracket with

2. Measure from the bottom of the air deflector to the bottom of

3. Cut the duct to the measured size (X).

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

7. Reassemble the air deflector to the duct cover bracket with

8. Seal connections with vent clamps.

2 - assembly screws provided with the Recirculation Kit.

A. Vent cover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet

outlet from the hood.

2 assembly screws.