ABB JSHD4 원본 사용 설명서 - 페이지 12

{카테고리_이름} ABB JSHD4에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB JSHD4 20 페이지. Three-position enabling device

Installation and maintenance

If a complete and ready to install unit is at hand, connect the cable to the control unit and connect enabling device

to the cable. Otherwise, first assemble top and bottom part and, if needed, the anti-tampering unit (PCB) following

the instructions below.

1. If used, insert pins from anti-tamper unit (D) into connector (B) from handle (A).

13: Red

14: Black

2. Insert PCB as shown, components facing forward. Push it all the way in.

3. If no anti-tamper is used, a jumper may need to be inserted between positions 14 and 16 in connector (B),

depending on bottom part.

4. Remove protective liner from gasket (C) on handle.

5. Join connectors (B) and (E).

6. Press bottom part (F) against handle and tighten screws (G).

JSM55 installation

1. 1080°

2. 2-3Nm

SW=4mm

2TLC172052M0201, rev. A

2011-10-06

15: Blue 16: Pink

JSM 55 is designed to fit onto ABB/Jokab Safety

Quick-Guard aluminium fencing extrusions, but

can be used on any flat surface.

If the two pre-mounted nuts are used, place

them in the groove in the extrusion, and then

loosen each screw three turns before tightening

them.