AER Lily one 설치 매뉴얼 - 페이지 6

{카테고리_이름} AER Lily one에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AER Lily one 12 페이지. Twin source rechargeable pick up system for acoustic instruments
AER Lily one에 대해서도 마찬가지입니다: 빠른 시작 (3 페이지)

페이지 인쇄

4. Endpin Mounting

•

After drilling the 12 mm hole in the guitars

end block, guide the preamp unit into the

sound hole and slip the pre-amp endpin

through the endpin hole and preselect

the correct position with the hex counter

nut inside the guitar. Then fix the endpin

finally with the second hex nut from the

outside, pushing an allen key through the

hole in the thread for use as lock against

twisting. When the endpin is safely fixed,

screw on the strap-button.

•

Now plug the piezo pickup connector

into the piezo socket of the endpin, there

should be an audible „click", to make sure

it sits firmly. The internal microphone

is best pointed towards the back of the

guitar.

5. Soundhole Control Unit

•

Now connect the soundhole control unit

with the small connector. You can then

connect the output jack to an amplifier.

Plugging the jack into the endpin socket

closes the circuit and switches on the

Lily one system, without jack there is no

battery power consumption. Even when

not playing, the system will lose battery

power when a jack plug is connected.

•

Factory settings:

Piezo: +10dB

Microphone: +10dB

•

Check the sound of the piezo pickup first

and listen if all strings sound equally loud.

Imbalance in string volumes should be

addressed by a luthier, or follow the tips in

the trouble shooting section.