AER Lily one Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria do instrumentów muzycznych AER Lily one. AER Lily one 12 stron. Twin source rechargeable pick up system for acoustic instruments
Również dla AER Lily one: Szybki start (3 strony)
Drukuj stronę4. Endpin Mounting
•
After drilling the 12 mm hole in the guitars
end block, guide the preamp unit into the
sound hole and slip the pre-amp endpin
through the endpin hole and preselect
the correct position with the hex counter
nut inside the guitar. Then fix the endpin
finally with the second hex nut from the
outside, pushing an allen key through the
hole in the thread for use as lock against
twisting. When the endpin is safely fixed,
screw on the strap-button.
•
Now plug the piezo pickup connector
into the piezo socket of the endpin, there
should be an audible „click", to make sure
it sits firmly. The internal microphone
is best pointed towards the back of the
guitar.
5. Soundhole Control Unit
•
Now connect the soundhole control unit
with the small connector. You can then
connect the output jack to an amplifier.
Plugging the jack into the endpin socket
closes the circuit and switches on the
Lily one system, without jack there is no
battery power consumption. Even when
not playing, the system will lose battery
power when a jack plug is connected.
•
Factory settings:
Piezo: +10dB
Microphone: +10dB
•
Check the sound of the piezo pickup first
and listen if all strings sound equally loud.
Imbalance in string volumes should be
addressed by a luthier, or follow the tips in
the trouble shooting section.