CALECTRO eSENSE 설치 매뉴얼 - 페이지 3

{카테고리_이름} CALECTRO eSENSE에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CALECTRO eSENSE 3 페이지. Co2 transmitter

Self diagnostics

The system contains complete self diagnostic procedures that is executed automatically when

the sensor is in operation. Sensors with display show a wrench if an error is found. The

wrench is shown during the first seconds after power up and if the measuring range 2000 ppm

is exceeded. The output OUT2 indicates the same information by setting the output voltage to

1V.

PLEASE NOTE!

The sensor accuracy is defined at continuous operation (at least 3 weeks after

installation).

CALECTRO AB

Box 4113

SE-426 04 Västra Frölunda

Sweden

Tel. +46 31-69 53 00

Fax. +46 31-29 32 91

Homepage: www.calectro.com E-mail: [email protected]

eSENSE

Figure 2. The

This product is in accordance with the

EMC Directive 89/336/EEC and the

Low Voltage Directive 73/23/EEC

including amendments by the CE-marking

Directive 93/68/EEC

The product fulfils the following demands:

EN50081-1, EN55011(B)

EN50082-2, EN61000-4-2,-3,-4,-5, Level3

eSENSE

and

PCB

3 of 4