CALECTRO eSENSE Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Nadajnik CALECTRO eSENSE. CALECTRO eSENSE 3 stron. Co2 transmitter
Self diagnostics
The system contains complete self diagnostic procedures that is executed automatically when
the sensor is in operation. Sensors with display show a wrench if an error is found. The
wrench is shown during the first seconds after power up and if the measuring range 2000 ppm
is exceeded. The output OUT2 indicates the same information by setting the output voltage to
1V.
PLEASE NOTE!
The sensor accuracy is defined at continuous operation (at least 3 weeks after
installation).
CALECTRO AB
Box 4113
SE-426 04 Västra Frölunda
Sweden
Tel. +46 31-69 53 00
Fax. +46 31-29 32 91
Homepage: www.calectro.com E-mail: [email protected]
eSENSE
Figure 2. The
This product is in accordance with the
EMC Directive 89/336/EEC and the
Low Voltage Directive 73/23/EEC
including amendments by the CE-marking
Directive 93/68/EEC
The product fulfils the following demands:
EN50081-1, EN55011(B)
EN50082-2, EN61000-4-2,-3,-4,-5, Level3
®
eSENSE
®
-
D
and
PCB
3 of 4