Bad Dawg 793-1086-00 설치 매뉴얼 - 페이지 6
{카테고리_이름} Bad Dawg 793-1086-00에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bad Dawg 793-1086-00 12 페이지. For intimidator electric utvs with new style converters
페이지 인쇄Step
10
Remove the glove box compartment, or other structures to gain access to the DC/DC converter wire Deutsch
connectors (Figure 15).
Figure 15: Connectors - View from Removed Glove Box
Step
11
Unplug the Deutsch connections on the converter f rom the UTV harness. Keep all connectors within reach.
Step
12
The winch wiring harness is equipped with Deutsch connectors that correspond with the connectors on the 60
AMP (largest) converter. Connect each connector with its corresponding plug. Triangle to triangle, square to
square, male to female. (Figures 16 & 17).
Figure 16: Winch Wiring Harness
*Note:
Check winch wiring harness for correct pin locations. Relocate pins if necessary.
Step
13
Route the red and black wires of the harness to the corresponding terminals on the battery (Figure 18).
Figure 18: Battery Wiring
PAG E 5
|
Wi n ch I n s ta l l a t ion
Figure 17: Winch Wiring Harness Pinned Correctly
Wiring for 48v to 12v Converter
Frame Harness
Blue
48+
Yellow
Ground
White
Key On
New Style
Red
Black
Blue