3Com IntelliJack NJ200 보충 설명서 - 페이지 4
{카테고리_이름} 3Com IntelliJack NJ200에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com IntelliJack NJ200 14 페이지. Network jacks
3Com IntelliJack NJ200에 대해서도 마찬가지입니다: 소프트웨어 설명서 (7 페이지), 데이터시트 (4 페이지)
페이지 인쇄
3 C O M
®
N J 2 0 0 N E T W O R K J A C K — V L A N S & T R A F F I C P R I O R I T I Z AT I O N
Figure 1. The ingress mode is applied to VLAN
traffic coming from the LAN before it gets sent
downstream to the PAN ports. The egress mode is
applied to VLAN traffic coming from the PAN ports
before it gets sent upstream to the LAN.
How the LAN port handles traffic coming from the LAN
NO
802.1 VLAN Tag Set?
Do not modify
Do not modify
tag information
tag information
Forward frame
to PAN port
Figure 2. 3Com Central Configuration Manager
GUI enables point-and-click remote administration
of NJ200 Network Jacks.
4
Inspect
Ethernet
frame
YES
NO
YES
Ingress rule set
to remove tag?
Remove all tag
information
Figure 1 provides a two-key schematic of the traffic-control process, including where
ingress and egress rules are applied. Configuring the ingress and egress modes is
accomplished using 3Com Central Configuration Manager:
1. Open the
Central Configuration Manager
Network Jack and then select
Property
and select
How the LAN port handles traffic coming from the PAN
NO
802.1 VLAN Tag Set?
YES
NO
Egress rule set
to add tag?
Do not modify
Add VLAN tag
information
tag information
. From the list of devices, select an NJ200
Property
. You can also right-click on its IP address
from the menu.
Inspect
Ethernet
frame
YES
Do not modify
tag information
Forward frame
to PAN port