ALCON CT-88 소유자 매뉴얼 - 페이지 7

{카테고리_이름} ALCON CT-88에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALCON CT-88 9 페이지.

페이지 인쇄

Setting a Representative number for

Remote/ Mobile Unit

setting your Remote/ Mobile unit representative number on the Base unit. l Set the POWER

switch of Remote / Mobile unit to OFF.

Base Unit

" Once you press the INT button, you must complete the following procedures within 5 sec-

onds to successfully complete the procedure.

Remote/ Mobile Unit

NOTE :

" To program a new Remote/Mobile unit to the original Base Unit, follow the same procedure

as above keeping in mind that it is necessary to have the same Group & Type. If you pro-

gram a new Remote/Mobile unit to the original that does not have the same Group or Type,

they will not be able to link.

1. Press SEL and without releasing turn

on the Base Unit.

2. All the LED indicators will be dis-

played and also Indicator No. 1.

3. Press SEL to change to the Remote

Unit No. that you wish to represent

either "2", "3" and "4".

4. Press the INT button.

NOTE :

5. Press and hold the INT button without

releasing and simultaneously turn on

the power of the Remote/Mobile Unit.

6. All the LED indicators on your

Remote/Mobile unit will turn on

simultaneously meaning that the pro-

cedure was successfully completed.

Switch

the

POWER

the

Remote/Mobile unit to OFF, and then

switch to ON again.

4. Pick up the Handset of the Normal

Telephone and see if the digit button

flashed is the number you setup.

OA-2538 HI-GAIN

ANTENNA INSTALLATION :

Note :

It is essential that the outdoor antenna be placed in a strategic

area to provide maximun communication range and clarity.

Before the base Station and the Handset unit are activated, be

sure to connect the Base Antenna to aviod damage.

ATTACHING THE TWO SECTIONS

1.Connet the two middle wires of each section of the antenna togeth-

er.

2.Use the mini-L wrench to fasten the screw given into the place

provided on the middle wire.

3. Connect the two sections together as tightly as possible.

ANTENNA MOUNTING

1. Mount the antenna support, using the U-Clamps given, to

an antenna mast (a long thin piece of wood. metal etc.)to

exten the overall height.

Note : Make sure that the material you use can witnstand

any climatic condition.

2. Connect the M-Jacks provided to both ends of the coaxial

cable.( if necessary ).

ANTENNA REFLECTOR MOUNTING

3. Screw the three reflectors securety in the botton part of the antenna into places provided.