Direct Healthcare Group 56-271 사용자 설명서 - 페이지 8

{카테고리_이름} Direct Healthcare Group 56-271에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct Healthcare Group 56-271 20 페이지.

9. Installing Seat with the Rear Opening (Accessory)

The seat comprises two halves that are snapped in place with the aid of clamps

on the seat's underside.

The sanitary pan is slid into position from behind between the seat and wire

guides as shown in fig. 10. Make sure the sanitary pan is slid into position above

the wire guides. Also make sure that the pan assumes the right position in relation

to the cutout/seat and that the pan's rear hook locks into the guide.

The foot rest can be easily set to the preferred height, swung aside (lift/swing) or

removed (lift away). Set footrest height by moving the green clip to the preferred

hole.

The Easy Hygiene Chair can feature 2 different types of wheels. The images show

the options.

A) Single wheel 125mm

The Hygiene Chair has 4 wheels (full brakes). The wheel on the right-hand front

side (grey brake pad) also features a directional lock.

B) Double wheel, 100mm

The Hygiene Chair has 4 wheels, of which the one on the righthand front side

features a directional lock and the other 3 are fitted with full brakes.

When the directional lock is activated, wheels cannot be turned. This is

particularly useful when moving heavier patients. The chair is thus significantly

easier for staff to push and control. The directional lock should be released

when manoeuvring in tight spaces. The other wheels (x 3)/green brake pad are

conventional wheels that lock both directionally and rotationally when the brakes

are applied.

The calibration of the actuators (height / lowering only) is normally done fully

automatically each time the chair reaches its end positions (min height, max tilt).

If the chair still does not go in parallel or if the tilt function does not seem to work,

an ACTIVE calibration can be done. This is done by holding down <button-slow /

up> + <button-slow / down> simultaneously.

After about 15 seconds the chair will be moved to its end positions ie. my height

and maximum slope backwards. Hold down the buttons until the end positions

are reached. Release the buttons and wait 5 seconds. The chair is now calibrated

and can be used again.

Calibration should NOT be done with user in chair. Note that all 3 actuators move

during the calibration phase. Otherwise, cancel the calibration immediately and

contact Customer Service.

EASY H I G H BA C K

DIRECTH E ALTH C A R EG RO UP.C O M