Direct Healthcare Group 56-271 Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wózek inwalidzki Direct Healthcare Group 56-271. Direct Healthcare Group 56-271 20 stron.
Drukuj stronę9. Installing Seat with the Rear Opening (Accessory)
The seat comprises two halves that are snapped in place with the aid of clamps
on the seat's underside.
10. Sanitary Pan
The sanitary pan is slid into position from behind between the seat and wire
guides as shown in fig. 10. Make sure the sanitary pan is slid into position above
the wire guides. Also make sure that the pan assumes the right position in relation
to the cutout/seat and that the pan's rear hook locks into the guide.
11. Footrest/Heel Restraint
The foot rest can be easily set to the preferred height, swung aside (lift/swing) or
removed (lift away). Set footrest height by moving the green clip to the preferred
hole.
12. Castors
The Easy Hygiene Chair can feature 2 different types of wheels. The images show
the options.
A) Single wheel 125mm
The Hygiene Chair has 4 wheels (full brakes). The wheel on the right-hand front
side (grey brake pad) also features a directional lock.
B) Double wheel, 100mm
The Hygiene Chair has 4 wheels, of which the one on the righthand front side
features a directional lock and the other 3 are fitted with full brakes.
When the directional lock is activated, wheels cannot be turned. This is
particularly useful when moving heavier patients. The chair is thus significantly
easier for staff to push and control. The directional lock should be released
when manoeuvring in tight spaces. The other wheels (x 3)/green brake pad are
conventional wheels that lock both directionally and rotationally when the brakes
are applied.
13. Calibrating the Actuators
The calibration of the actuators (height / lowering only) is normally done fully
automatically each time the chair reaches its end positions (min height, max tilt).
If the chair still does not go in parallel or if the tilt function does not seem to work,
an ACTIVE calibration can be done. This is done by holding down <button-slow /
up> + <button-slow / down> simultaneously.
After about 15 seconds the chair will be moved to its end positions ie. my height
and maximum slope backwards. Hold down the buttons until the end positions
are reached. Release the buttons and wait 5 seconds. The chair is now calibrated
and can be used again.
Calibration should NOT be done with user in chair. Note that all 3 actuators move
during the calibration phase. Otherwise, cancel the calibration immediately and
contact Customer Service.
8
EASY H I G H BA C K
DIRECTH E ALTH C A R EG RO UP.C O M
9
10
b
a
b
11