Direct IP DC-E Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} Direct IP DC-E Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct IP DC-E Series 18 페이지.

페이지 인쇄

Part 1 – Introduction

Overview

Product color and design may vary depending on the model.

Body

1 2

Lens

IR LED

Body

Bracket

Cable

SD Memory Card Slot

• Lens

Fixed lens is installed.

• IR LED

A sensor in the bottom middle monitors lighting

levels and activates the IR LED during low-lighting

conditions.

• Body

The cables are connected through the body.

• Bracket

Allows you to mount the camera to the wall or ceiling.

• Cable

Refer to the Cable.

• SD Memory Card Slot

Used to insert a microSD memory card into the

camera. (An SLC (Single Level Cell) or MLC (Multi Level

Cell) card by SanDisk or Transcend is recommended)

Remove the lens rear side's cover in order to remove

or insert the SD memory card. Make sure that the

cover is joined properly when screwing it; otherwise,

the IP66 level is not guaranteed.

• To remove/insert the SD memory card or

perform the factory reset, make sure that the

cover is joined properly when screwing it.

Otherwise, the IP67 level is not guaranteed. For

more information, contact your product retailer.

• Do not remove the SD memory card while the

system is in operation. Removing the card while

the system is in operation can cause the system

to malfunction and/or corrupt data stored on

the SD memory card.

• An SD memory card is a consumable product

with a finite service life. Prolonged use will

damage the card's memory sectors and result

in data loss or memory card failure. Test the SD

memory card regularly and replace it whenever

necessary.