Direct IP DC-E Series Installation Manual - Page 8

Browse online or download pdf Installation Manual for Security Camera Direct IP DC-E Series. Direct IP DC-E Series 18 pages.

Print Page
Part 1 – Introduction

Overview

Product color and design may vary depending on the model.

Body

1 2
3
Lens
1
IR LED
2
Body
3
Bracket
4
Cable
5
SD Memory Card Slot
6
8
4
6
• Lens
Fixed lens is installed.
• IR LED
A sensor in the bottom middle monitors lighting
5
levels and activates the IR LED during low-lighting
conditions.
• Body
The cables are connected through the body.
• Bracket
Allows you to mount the camera to the wall or ceiling.
• Cable
Refer to the Cable.
• SD Memory Card Slot
Used to insert a microSD memory card into the
camera. (An SLC (Single Level Cell) or MLC (Multi Level
Cell) card by SanDisk or Transcend is recommended)
Remove the lens rear side's cover in order to remove
or insert the SD memory card. Make sure that the
cover is joined properly when screwing it; otherwise,
the IP66 level is not guaranteed.
• To remove/insert the SD memory card or
perform the factory reset, make sure that the
cover is joined properly when screwing it.
Otherwise, the IP67 level is not guaranteed. For
more information, contact your product retailer.
• Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
• An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.