Direct IP DC-E4213WRX 설치 매뉴얼 - 페이지 10
{카테고리_이름} Direct IP DC-E4213WRX에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Direct IP DC-E4213WRX 18 페이지.
Direct IP DC-E4213WRX에 대해서도 마찬가지입니다: 빠른 매뉴얼 (17 페이지)
페이지 인쇄
Part 1 – Introduction
Inserting a SD Memory Card
1
Loosen the screws counterclockwise and remove the
cover.
2
Insert a SD memory card into the SD memory card
slot with the 'micro SD' print facing upward.
Push the SD memory card until it disengages from the
slot, and then pull it out.
3
Cover the lens cover and tighten the screws
clockwise.
10
Make sure that the cover is joined properly when
screwing it; otherwise, the IP67 level is not guaranteed.
Waterproof Cable Installation
RJ45 waterproof rubber ring
RJ45 modular jack
RJ45 waterproof rubber ring
RJ45 modular jack
1
1
2
1
Insert a round rubber ring (silicone rubber) into the
RJ45 jack.
2
3
2
Insert the network cable into the waterproof cap,
rubber bushing, and waterproof cap body in order.
3
4
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover
RJ45 connector protect cover
cable waterproof rubber ring
(The waterproof rubber ring is fastened to the connector protect cover.)
RJ45 connector back cover