Acond Hydromodul HM 설치 매뉴얼 - 페이지 9

{카테고리_이름} Acond Hydromodul HM에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acond Hydromodul HM 17 페이지.

Hydromodul

6.1.1 Electrical preparation

The electrical connection is made from the bottom side, where leave a free cable length of at

least 2m. The cables to be brought in are given by the diagrams annexed to this document.

The indoor C-ID room unit shall be placed in a heated reference room. The heating rod will be

switched if the temperature in the reference room unit drops below the set temperature in the

AcondTherm regulation.

A thermostatic valve shall not be placed in the reference room.

When installing, follow the order as shown below.

7.1 Mounting of the attached assembly

Attach the included assembly with pliers above the Hydromodule covers, see the following

picture. Use the seal correctly.

Installation manual