Acond J1-01 사용 설명서 - 페이지 5
{카테고리_이름} Acond J1-01에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acond J1-01 9 페이지.
페이지 인쇄Operation instructions
Operation modes
Selecting mode
Each time MODE button is pressed, the operation mode
is changed in sequence:
COOLING
DRY
Heating mode is NOT available for cooling only air conditioner.
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
Auto
At "FAN ONLY" mode, only "High","Medium" and "Low" are available.
At "DRY" mode, Fan speed is set at "AUTO" automatically, "FAN" button
is ineffective in this case.
Setting temperature
Press once to raise temperature setting by 1℃
Press once to lower temperature setting by 1℃
Range of available set temperature
*HEATING, COOLING
DRY
FAN ONLY
Note: Heating mode is NOT available for cooling only models.
Note: At "Dry" mode, the unit can decrease or rise 2℃ if you still
feel uncomfortable.(For the inverter you can choose from -7 to 7.)
Press
button, when the appliance receives the
signal, the RUN indicator of the indoor unit lights up.
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, SLEEP and SUPER operation modes will be
specified in the following pages.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
Wait 3 minutes before restarting the appliance.
FAN ONLY
HEATING
FAN mode
High
Medium
Low
18℃~32℃
-7 ~ 7
unable to set
Turning on
1
SWING
SMART
TIMER ON TIMER OFF
3
ON
ON
OFF
OFF
ON/OFF
MODE
FAN
SLEEP
SUPER
IFEEL
DIMMER
CLOCK
3