Xerox WORKCENTRE 7120 시스템 관리자 매뉴얼 - 페이지 20

{카테고리_이름} Xerox WORKCENTRE 7120에 대한 시스템 관리자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox WORKCENTRE 7120 20 페이지. Color networking mfp a3
Xerox WORKCENTRE 7120에 대해서도 마찬가지입니다: 평가자 매뉴얼 (25 페이지), 평가자 매뉴얼 (24 페이지), 참조 매뉴얼 (30 페이지), 사양 (14 페이지), 사양 (14 페이지), 경쟁사 비교 (11 페이지), 경쟁사 비교 (11 페이지), 브로셔 및 사양 (4 페이지), 참조 매뉴얼 (29 페이지), 빠른 사용 설명서 (20 페이지), 빠른 사용 설명서 (20 페이지), 빠른 사용 설명서 (20 페이지), 빠른 사용 설명서 (20 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 빠른 사용 설명서 (20 페이지), 참조 매뉴얼 (32 페이지)

Network Configuration

TCP/IP

Transmission Control Protocol (TCP) and Internet Protocol (IP) are a two protocols within the Internet

Protocol Suite. IP manages the transmission of messages from computer to computer while TCP

manages the actual end-to-end connections.

Note:

You can configure IPv4 settings at the printer control panel or through CentreWare IS. You

can only configure IPv6 through CentreWare IS.

Enabling TCP/IP

Note:

By default, TCP/IP is enabled. If you disable TCP/IP, you must enable it at the printer control

panel before you can access CentreWare IS.

At the printer control panel, press the Machine Status button, then touch the Tools tab.

Touch Connectivity and Network Setup > Protocol Settings.

Touch TCP/IP - IP Mode, then touch Change Settings.

Touch IPv4 Mode, IPv6, or Dual Stack to enable both IPv4 and IPv6.

Touch Save.

Configuring TCP/IP Settings at the Control Panel

Manually Configuring an IPv4 Network Address

At the printer control panel, press the Machine Status button, then touch the Tools tab.

Touch Connectivity and Network Setup > Protocol Settings.

Touch IPv4 - IP Address Resolution, and touch Change Settings.

Touch Static, then touch Save.

Touch IPv4 - IP Address, and touch Change Settings.

Type the static IP address using the touch-screen keypad, and touch Save.

Touch IPv4 - Subnet Mask, and touch Change Settings.

Type the subnet mask using the touch-screen keypad, and touch Save.

Touch IPv4 - Gateway Mask, and touch Change Settings.

10. Type the gateway mask using the touch-screen keypad, and touch Save.

Manually Configuring an IPv6 Network Address

At the printer control panel, press the Machine Status button, then touch the Tools tab.

Touch Connectivity and Network Setup > Protocol Settings.

Touch IPv6 Address Manual Configuration, then touch Change Settings.

Touch Enabled, then touch Save.

Touch Manually Configured IPv6 Address, then touch Change Settings.

Type the static IP address using the touch-screen keypad, and touch Save.

Touch Manually Configured IPv6 Address Prefix, and touch Change Settings.

WorkCentre 7120 Multifunction Printer

System Administrator Guide