Installing Option Kits
This section provides instructions on how to install and configure optional features:
• Network Scanning
• Hard Disk Overwrite
• Server Fax
• Network Accounting
NOTE:
For instructions on installing and configuring Server Fax and Network Accounting,
refer to the System Administration CD.
Installing Option Kits
All the Option Kits are installed in the same way. Each kit will contain a Feature Enablement
Key and instructions.
1
With the WorkCentre switched on, insert
the Feature Enablement Key into the Card
Reader slot just above the On/Off switch on
the left hand side of the machine.
2
When the feature is successfully installed a
pop-up message will tell you that the
feature is configured and ask you to
remove the Feature Enablement Key.
Network Scanning
Network Scanning is an optional feature, available for the WorkCentre 4150s, 4150x and
4150xf, and can be purchased from your Xerox Sales Representative.
Network Scanning enables you to convert your hard copy documents to electronic files and
retrieve them from a server or workstation on the network.
There are two ways to configure Network Scanning:
• Use Internet Services, the WorkCentre's embedded web server, to set up the
Network Scanning feature. Installation and setup of this feature is described below.
• FreeFlow™ SMARTsend™ is an optional application that will scan to a variety of
destinations. Installation and setup of this feature is described in the FreeFlow™
SMARTsend™ System Administrators CD that comes with the application.
NOTE:
Scanning services should be enabled on your network before you enable the
Network Scanning option.
Install Internet Services Network Scanning
1
Configure the option. Refer to Installing Option Kits on page 15
Create a Network Scanning Repository
2
At your PC, open your web browser and enter the Host Name or IP address of the
WorkCentre.
3
Select Properties > Services > Network Scanning > File Repository Setup.
getting started guide
Card Reader
slot
15
페이지 인쇄