Xerox 4150xf - WorkCentre B/W Laser 시작하기 매뉴얼 - 페이지 8

{카테고리_이름} Xerox 4150xf - WorkCentre B/W Laser에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 4150xf - WorkCentre B/W Laser 38 페이지. Network scanning - wia configuration
Xerox 4150xf - WorkCentre B/W Laser에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 빠른 참조 (1 페이지), 카트리지 교체 (1 페이지), 설치 지침 매뉴얼 (40 페이지), 모듈 설치 매뉴얼 (1 페이지), 하드웨어 설치 매뉴얼 (1 페이지), 트레이 모듈 설치 매뉴얼 (1 페이지), 모듈 설치 매뉴얼 (1 페이지), 설치 매뉴얼 (6 페이지), 매뉴얼 (9 페이지)

페이지 인쇄
Xerox 4150xf - WorkCentre B/W Laser 시작하기 매뉴얼

Switch On the WorkCentre

Once the WorkCentre has been assembled it must be configured. This is done using the
Product Enablement Key when the machine is switched on for the first time.
The Product Enablement Key is delivered
in a plastic tube inside the box with the
machine. The procedure to configure the
machine is as follows:
1
Locate the tube containing the Product
Enablement Key. Remove the plastic
card and carefully press out the key.
2
Install the Product Enablement Key into
the Card Reader Slot on the left side of
the machine.
Product Enablement
Key
3
Connect the Power Cord to the machine and a suitable power supply outlet.
4
Switch on the machine.
5
The Language Default screen will be displayed. Select your chosen language and then
select Save.
6
The Installation Wizard screen will be displayed. Select Next.
7
The Product Enablement Settings screen will be displayed. Follow the instructions on the
screen.
NOTE:
When the Green LED light stops blinking and remains on continuously (about 10
seconds), the configuration is successful.
Remove the Product Enablement Key and select Next on the display
4
On/Off Switch
Power Cord
Card Reader
slot
Green LED
getting started guide