Xerox 460 정보 매뉴얼 - 페이지 7

{카테고리_이름} Xerox 460에 대한 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Xerox 460 13 페이지. Macintosh driver information
Xerox 460에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (38 페이지)

dc00cc0135

Document Centre Technical Support Operations

DocuTech Emulation

The DocuTech PPD offers the same features as its partner, either the custom or generic DC

PPD. The DocuTech PPD emulates the output of a DocuTech, specifically the resolution,

margins and halftones. This feature is typically used by customers who have both a

Document Centre 265/255/240 or 490/460 and a DocuTech and want to proof or sample

output files on the Document Centre and then run the final version to the DocuTech.

When accessing the custom driver UI, the option for DocuTech appears to be available at all

times. Note that you must use the DocuTech PPDs in order for this option to work properly.

Depending on the printer driver in use, ensure that you are using the correct or compatible

PPD for DocuTech emulation. See the Printer Drivers/PPDs table earlier in this document.

Configuring the High Cap Feeder and Finisher

If the High Cap Feeder and Finisher are installed on the DC 265/255/240 or 490/460,

configure the driver as follows:

1. Open the Chooser.

2. Select the [Xerox DC] driver.

3. Select the DC 265/255/240 or 490/460 network printer in use.

4. Select [Setup].

5. Press [Select PPD].

6. Select the custom PPD or the DocuTech emulation PPD.

7. Press [Select].

8. Press [Configure].

9. Select [Install] for the High Cap Feeder and Finisher options.

10. Select the appropriate product for the System Configuration.

11. Select <OK> to confirm the selections and exit Chooser.

This procedure sets up the DC 265/255/240 or 490/460 driver as the default. If you switch

back and forth between printers, check the configuration every time you select the Xerox

DC 265/255/240 or 490/460 as default to ensure that the settings for the High Cap Feeder

(Tray 6) and Finisher are still active.

Page 7